Mfg, Nerd, #Entgineer, & #GladScientist, 🛸lifting minds to otherworldly realms with the power of physics 👽 #BecomeABeliever #GoForADryV #SeeTheLight refc-labs.com

  • 42 Posts
  • 223 Comments
Joined 2 years ago
cake
Cake day: June 14th, 2023

help-circle



  • Your intuition is spot on.

    Elon is gutting USAID because they were investigating him over starlink. Elon is gutting the government agencies that oversee electric car regulations and safety regulations. Elon is going after the SEC for investigating him. Elon is using the government’s databases to amass data to target political and business competitors and to further the far right propaganda campaigns as well as build list of deportees and political targets. Elon is gutting every TLA he can to ensure his taxes decrease and yours increase. Elon is tearing through decades of support and opportunity programs designed to help the less fortunate/less abled to live comfortably so he can live more comfortably.

    Everything he’s doing, is for his own benefit and personal gain, to the extreme detriment of the entire country. He’s neither qualified nor elected. His actions should amount to treason, but they’re being enabled by a traitorous, treasonous, felonious criminal, the shittiest president this country has ever seen.














  • If this is new, think you have a wheel adjusted too tight. When this happens, during rest it develops a small flat spot which translates to mechanical ringing in the print. If you let the machine sit for a while, then slowly move that axis, do you feel a bump where it was at rest? All of the axes should be smooth with no felt noise. If you feel noise, you’ll see it in prints.

    If not, I would inspect your axis rails for any contaminants or damage, I used one of my printers so much I wore out the actual aluminum extrusion on the y axis and the bed was developing mechanical slop, which was actually difficult to find until I checked the bearing races.