Balloon animals.

Crossing your eyes will show you the opposite effect though, something being concave instead of convex.

Can you elaborate? Is there any controversy on the Core One I’m not aware about, apart from it being less open source?

You should try non-filtered water with your coffee machine and see if it makes a difference in taste. Some coffee aficionados actually re-add minerals after filtering the water

Zerowater removes all dissolved minerals from the water, which is actually bad for you if you only drink that.

Thanks, I just loosened the extruder idler (?) to roll it back up and restarted the print. Didn’t think of cleaning the filament first, but anything touching the floor has gone through the hotend now.

There was quite a bit of initial config to do, but there is Linux OneDrive Client, and OneDriveGUI

I remember the last time I read a similar story, it was mainly toddlers that died. So… Mixed bag.

Thanks for the writeup! The mmu3 assembly instructions do mention I need longer PTFE tubes if I want to combine it with the enclosure, so I dont think there’s avoiding that. We’ll have two enclosures with MMUs next to each other, so having the spools hanging on the outside feels a little too unsightly.

I’m eyeing the (un)original drybox too, but it’s adding quite a bit of cost.

And hardware upgrades.

Do you have any advice on putting the spools inside the enclosure? I haven’t put our MMU3s together yet, but all the official photos show the spools on the outside.

“Nooo”

I read this in French first, which made it funnier.

I’m sorry, a ‘Minecraft related cause’?

Most of the CAD software mentioned here will not be super helpful in modifying meshes (like STLs), but they’re great if you want to redesign the part from scratch :)

Tinkercad is the exception, as it works with meshes and booleans.

Very à propos

OK, but why is Leonard Cohen walking into an Apple store?

That’s a total of 116%. Edit: just read it again, sorry!

Webcomics.

deleted by creator